Product Description
Free Shipping
Snap Check Gauge is one of iGaging’s newest products.
It comes installed with 3 strong neodymium magnets on the base leaving both hands free to adjust the machine in question, even if the surface is not steel/cast iron, the Snap Check is still heavy enough to hold its own weight without being moved as you adjust the tooling
The Snap Check plunger is spring loaded and can display readouts in mm, inches, and fractions, and comes with 2 anvil tips; BALL tip and FLAT tip.
The plunger is spring loaded and can display readouts in mm, inches, and fractions.
Specifications:
- 3-Way Reading: Inch - Metric - Fraction
- Resolution: 0.0005"- 0.1mm - 1/64"
- Hold function
- Measuring Range: 0-2"
- Measuring Depth Range: 0-16"/0-400mm
- Accuracy: ± 0.001" - 0-1"
- Spring-loaded travel
- Magnetic base
- Strong Magnetic Base for strong holding on metal surface
Application:
Setting Jointer Knives:
These are very difficult to get right, once you’ve found top dead center, you can move the snap check across the knives to verify the are the same height all the way across.
You can also calibrate the difference in height between the in and out feed of the jointer.
Setting Table saw Blade Height:
Another useful application would be setting the height of your table saw blade, using the built in neodymium magnets, you have both hands free to adjust the height of the blade to ensure the exact height of the blade, you can also measure blade run-out/wobble if your fence is made of the right material, if your fence is made of a plastic or another material that doesn’t attract magnets, you can always just hold the snap check against the fence. Make jointer knives, table saw, and router table set up easy.
Setting Router Table Height:
This tool shine for setting router table heights, some router bits are angled towards a peak, and holding a metal rule next to the router bit is not always accurate.
- Auto Shut-off
- Flat & Ball tip Anvils included
- Battery: 3V CR2032 included
