Product Description
Free Shipping
The spindle is made to use with a Baldor Dental Polishing motor. Spindle is fits 3/8" Polishing lathes has an inside diameter that is tapered to fit on the tapered shaft of a Baldor Dental Polishing motor. These are specifically made to fit Baldor motor shafts since they are not straight, but have a slight taper.
Spindles are a friction fit, they are pushed on to the shaft of the Baldor motor, to properly secure them onto the shaft, lightly tap with a soft mallet or a piece of wood. To remove, just use the screw off spindle remover on the motor by simply unscrewing and turning it until the spindle is pushed off of the tapered shaft.
Spindles is made of cold rolled steel is machined to close tolerances, made in U.S.A.
Spindle has a 3/8" Tapered arbor hole to work on the LEFT Side of Baldor 3/8" shaft motors. The spindle arbor hole has a slight tapered to fit and be held on the Baldor Motor Lathes LEFT Side shaft. Note: Spindle does not have tightening screws.
Specifications:
- Material: Cold Rolled Steel
- Overall Length: 3-3/8" - 87mm
- Spindle Body Length: 1-3/8" - 35mm
- Spindle Tapered Length: 2" - 51mm
- Arbor Hole: 3/8" Tapered Friction Grip to Shaft
- Weight: 2.75oz.
Features:
- Precision Quality
- Machined - High Speed Lathe
- Made from 3/4" Stock Material
Spindle is made to be used on a 3/8" tapered shaft diameter and on the Left Hand Side of Motor with forward direction.
